Laser cutting machine in operation must comply with the matters
Laser cutting machine in operation must comply with the matters
For the laser cutting machine operation, we know how to operate,But How to pay attention to some of the details during the operation?Note that these questions will be able to make better use of laser cutting machine,Reduce the harm to the personnel and machinery.
¡¡¡¡
a.To fire extinguisher placed in a readily accessible place;
Not processed to turn off the laser or shutter;
Of paper, cloth or other combustible materials are not placed near the laser beam in the unprotected.
b.Not ascertain whether a particular material can be used laser irradiation or heating, not to its processing, to avoid the potential dangers of smoke and steam.
¡¡¡¡
c.Good labor required to wear protective equipment, must wear the required protective glasses in the vicinity of the laser beam.
¡¡¡¡
d.To comply with the safe operation of laser cutting machine. We need to start the laser cutting machine in strict accordance with the laser startup program, operating.
f, Equipment switched on when operating personnel are not allowed to leave their posts or the Trustee to be the tube, such as it does need to leave should be shut down or cut off the power switch.
¡¡¡¡
e,Boot after manual low speed X, Y direction to start the machine, check to make sure whether the abnormal situation.
¡¡¡¡
g.Abnormal, should be immediately shut down, timely troubleshooting or reported to the executive officers in the process.
¡¡¡¡
h,Maintain laser cutting machine bed and the surrounding grounds neat and orderly, without oil, the workpiece, plate, scrap required stacking.
¡¡¡¡
i,Operator shall be trained and familiar with the device structure, performance, and the master operating system knowledge.
¡¡¡¡
j,Maintenance to comply with the high pressure safety procedures. In accordance with the provisions and procedures.
¡¡¡¡
k,Use of gas cylinders,Should be avoid crushed welding wire in order to avoid leakage accident occurred.Gas cylinders, use, transport, shall comply with the cylinder to monitor the point of order.Cylinder prolonged sun exposure in the sun or near heat sources is prohibited.Open the valve, the operator must stand in the side of the lip.
